how do you program LP 12's?

[zzyzx]

How do you program LP 12's?

[akroeze]

How do you program LP 12's?

Wow... ummm.... that's quite the broad question you have there.

[zzyzx]

Sorry, I should have been more clear. What I mean is, how do you change the set up/configuration. For example, if you always want the monitor to show leads I, II, and capnography, or if you want to always have the pacer be in demand mode, or whatever.

[scratrat]

Refer to the manual. You will need the code from the factory and a preset way of pressing of buttons to access that menu. I don't remember the default, but if you call the complany they can tell you. You can change the BP cycle, default leads, default alarms, etc etc.

[scratrat]

Enter the setup menu; by pressing and holding the OPTIONS key and the

EVENT key, while turning the unit ON.

• Enter setup mode Pass Code (typically “0000”) to get to the Setup Menu

[scratrat]

http://www.aedhelp.com/op_instructions/3010012-017.pdf

Took me a little while, but I found it!!

Starts on page 195.

MAKE SURE YOU KNOW WHAT YOU ARE DOING FIRST!!!!!

Whatever you change, will stay that way until you change it back, read it first in case you mess with something you shouldn't have.

Sorry, I was going to delete all my previous posts, but admin says NO!

[zzyzx]

Thanks, Scatrat!

[celticcare]

How do you program LP 12's?

Hehehehe Dust would probably say "With his boot"

Sums it up hehehe

[CBEMT]

If all you're trying to do is change the display waveforms, just turn the dial clockwise to the line you want to change, click the knob, then select what you want it to show.

[akflightmedic]

I think the original poster figured it out by now, since I noticed Celtic revived a 2 year old thread.